![]() Install the GDB Hardware Debugging plugin. The GDB's "monitor reset halt" is not working (the board hangs) 2. This seems to work fine, I now want to have my application section start at the offset. ![]() The next step would be to setup a debug configuration and begin debugging! Go to Window > Preferences > Run/Debug > String Substitution and make sure openocd_path refers to the bin folder of the OpenOCD installation.cpu - Not halted Runtime Error: openocd_iconnect. I am not sure what settings are the right ones above, but it seems to detect the device OK. cfg mon reset - Reset Tessel and all on-chip peripherals (like the reset button) mon soft_reset_halt - Reset the CPU only Other notes. Click on the little green bug icon in the Eclipse toolbar and select Debug Configurations…. ![]() I guess this is a software issue rather than soldering issue or hardware damage. 1) OpenOCD tells MCU to switch on HSE, PLL, etc and continue at full speed by writing to RCC registers.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |